The new masterstream - a unique class of circulation pumps
The Turbelle® masterstream pumps are for the high-performance propeller pump market segment, and primarily intended for an implementation in experience zoos, research institutes, rehabilitation clinics and farms. But there is also a model for aquarists who operate large aquariums and require a strong as well as wide flow rate for their reef tanks. Turbelle® masterstream pumps are designed to provide a maximum degree of efficiency, combined with a low energy consumption. Thanks to the extra-low safety voltage of the new electronic Tunze® PM motor, the pumps will operate at a pleasant noise level even at peak performance, while consuming significantly less power for the same output compared to conventional water pumps.
|
Hose clamps for attachment to PVC pipe or rod, diam. 32 mm (1.25 in.).
|
|
The pump housing is used as a huge intake strainer; the suction area is 3.95 times larger than the discharge area. The Turbelle® masterstream needs no additional intake strainer.
|
|
Performance propeller with low rotational speed and axle made of titanium alloy.
|
|
Flow ejector, diam. 125mm (4.91 in.) with integrated protection against injury in keeping with European standard EN 60335-1.
|
|
Corrosion-resistant screws with nuts.
|
|
An intelligent and innovative micro-processor controlled PM motor operating on safety extra-low voltage of 12 V to 24 V is the core of the new Turbelle® masterstream.
|
|
Turbelle® masterstream
CONTROLLABLE PERFORMANCE
The Turbelle® masterstream are electronically speed-controlled pumps operating on safety extra-low voltage of 12 V to 24V. They can be used ideally for water circulation, wave action or wave-and-tide simulations.
A 12 V VERSION FOR SWIMMING POOLS
Model 6560 in 12V technology and a flow rate of 60,000l/h (15,850 USgal./h) has been designed especially for swimming pools or large aquariums.
100 PER CENT CORROSION-RESISTANT
All parts of the pumps are made of sustainable active microbicidal (SAN) polymers and polyoxymethylenes (POM); the motor axle is made of titanium alloy; the motor and the electronics are cast in polyurethane (PU) resin.
NO EXTERNAL CONTROL
The pump control is integrated completely in the motor block ensuring a low-maintenance operation with high efficiency and ideal water cooling. All Turbelle® masterstream pumps only require one external power supply unit or safety connector with a corresponding direct-current source (battery, solar cell, et cetera).
NO PROBLEM IN CASE OF POWER FAILURE
Fitted with Safety Connector 6515.50, Turbelle® masterstream can be operated on every 11 V to 24 V direct-current source (battery, solar cell). The safety connector permits normal operation with the TUNZE® power supply unit, but in case of a power failure it will automatically switch over to a battery or a direct-current source.
|
|
Turbelle® masterstream
ECO ENERGETIC
A small sample calculation using Turbelle® masterstream 6580 (80m³/h – 420W) reveals that energy efficient water movement results in enormous cost effectiveness:
Tank volume: 60 m³, flow selection by centrifugal pump (32m³/h – 2,200W). At an annual operating time of 8,760 hours and a kilowatt price of EUR 0.28 this results in a cost saving of EUR 4,366 per annum !
|
|
Propeller technology
|
|
100% sea-water proof, titanium and plastic
|
|
Low motor heat
|
|
2D adjustment
|
|
Safety extra-low voltage
|
|
Controllable speed, wave simulation, tidal currents
|
|
|